When I designed this hitch tire carrier one of my main goals was to
make it universal as possible. Especially to help serve applications
where there isn’t an off the shelf tire carrier option.

However, your vehicle MUST meet these requirements:

1. Have a 2″ tow hitch installed

2. Able to access the back part of the tow hitch (if not, notch out until you can slide tube through)

3. Have at least 10.25″ of vertical clearance measuring from the inside bottom of the factory tow hitch and up. if not then the aux hitch will need to be welded in line with the anti-wobble witch will give you extra clearance making it only ~7.25″ of vertical clearance needed.

4. Factory hitch pin hole must be less than 4 inches from the edge of your rear bumper.

5. 35″ max tire/wheel (recommended)

6. Wheel lug pattern: 6×5.5, 5×4.5, 5×5.5, 8×6.5, 8x170mm (if you don’t see yours listed please contact me and I can make you custom pattern to fit your wheel pattern).

If your not sure what your wheel lug pattern is, please check here